SMC Networks ZSE30A series

-40-
No.PS※※-OML0003-J
Press the button to start copying.
The copy source Pressure switch
The copy destination Pressure switch
Sending/
Receiving
Copy
completed
(Red) (Green)
Press the
button.
To complete the copy function,
press the
and buttons
simultaneously for 1 second or longer. Setting of [F97] Copy function completed
∗: If the copy to the copy destination pressure switch is not completed, it is detected as a copy function sending/receiving error.
Press the
and buttons simultaneously for 1 second or longer to return to measurement mode. Then, check the wiring and
specifications of the switch and retry the copy function.
Press the and
buttons simultaneously
for 1 second or longer.
Press the button.
Flashing
(Red)
Flashing
(Green)
The copy ready status is held even if the power
supply is turned off.