Servodrives / inverters series COSMOS 301X Installation, use and maintenance manual - EN
2 GENERAL INSTRUCTIONS
The assembly instructions are an integral part of the equipment and must be kept for future reference, until it
is dismantled. The present instructions reflect the state of the art at the moment when the equipment was
sold; they will remain fully acceptable despite subsequent upgrades based on new experience.
DO NOT USE THE EQUIPMENT, NOR MAKE ANY INTERVENTION BEFORE INTEGRALLY
READING AND UNDERSTANDING THIS MANUAL.
IN PARTICULAR, ADOPT ALL SAFETY PRECAUTIONS AND PRESCRIPTIONS INDICATED IN THIS MANUAL.
THE EQUIPMENT CAN NOT BE USED FOR DIFFERENT PURPOSES THAN THE ONES DESCRIBED IN THIS
MANUAL; SMITEC S.p.A. SHALL NOT BE HELD RESPONSIBLE FOR ANY DAMAGES, INCONVENIENCES OR
ACCIDENTS DUE TO THE NON-COMPLIANCE WITH THE PRESCRIPTIONS.
In order to make the manual consultation easier, the following symbols have been adopted:
The indication of "FORBIDDEN BEHAVIOR".
The symbol "DANGER" is used when the non-compliance with the prescriptions or misuse
may cause serious injuries.
The symbol "DANGER OF HOT SURFACES" is used when the non-compliance with the
prescriptions may cause serious injuries.
The symbol "DANGER OF ELECTRICAL SHOCK" is used when the non-compliance with
the prescriptions may cause serious injuries.
The symbol "USE OF INDIVIDUAL PROTECTIONS" means that protective gloves must be
worn.
The symbol "USE OF INDIVIDUAL PROTECTIONS" means that protective glasses must
be worn.
The indication of "PARTICULAR RELEVANT INFORMATION".
Ver. 1.09 SMITECdd 5/74
To Next Page
Loading...