Servodrives / inverters series COSMOS 301X Installation, use and maintenance manual - EN
3 Safety instructions
3.1 General information
Do not install or use the equipment before integrally reading and understanding this
manual. In case of difficulties of interpretation, contact SMITEC technical service.
It is absolutely forbidden to use the equipment for different purposes than the ones
described in this manual. The technical data and the drawings in this manual might have
been modified later; always refer to the latest version. All upgrades can be requested to
SMITEC S.p.A. directly.
Make sure that the personnel is qualified and adequately informed about the risks he may
run and how to avoid them.
The COSMOS 301X series servo drives is authorized can be used only after the
classification of the machine operating area and after checking the safety levels, which
must correspond to the assembly safety levels.
Precautions during handling and assembly
Use adequate tools during the assembly, in order to avoid crushing or abrasions.
Metal components and sharp surfaces may cause cuts and tears. In case of contact, be
very careful and wear the personal protection equipment.
Ver. 1.09 SMITECdd 7/74
To Next Page
Loading...