22
Settings Settings Menu
z Disconnecting from a network, or remove password
1. Turn on the thermal imager and press the Menu button.
2. From the toolbar select the Settings icon.
3. Select Wi-Fi Connection from the menu.
4. Select the connected network, and press the Y button.
From the menu, select Disconnect or Forget Password.
Wi-Fi Status - Icon Identification
The following chart shows the WI-Fi icons used to indicate connection status.
Wi-Fi - ON / Connected to network
access point and Internet
Wi-Fi - ON / Alternate available
network access point
Wi-Fi - ON / Not connected to
network access point or Internet
Wi-Fi - ON / Network access
point password protected
Wi-Fi - ON / Connected to network,
not connected to Internet
Wi-Fi - ON / Actively connecting
to network access point
Wi-Fi - OFF
Wi-Fi - ON / Actively
disconnecting from network
access point
Wi-Fi Signal Strength (general):
Three bars - Full Strength Signal
Zero bars - Weak Signal
To Next Page
Loading...