Chapter 7 – Prestart Inspection
40 A46JRT – 0260996
0072530
0182236
Maintain 10 feet minimum clearance from electrical power lines and apparatus.
You must allow for platform sway, rock, or sag.
This aerial device does not provide protection from contact with or proximity to an
electrically charged conductor.
Death or serious injury will result from such contact or inadequate clearance.
DANGER
ELECTROCUTION HAZARD
THIS MACHINE IS NOT ELECTRICALLY INSULATED
0072530
0072530
Upper Controls
0151410
Radiator
0151410
Platform
0072531
0072531
0072541
• Do not operate this machine unless you are a qualified operator and have read and
thoroughly understand all information given in the Operator’s Manual and on DANGER
and CAUTION signs on this machine.
• Maintain 10 feet minimum clearance from electrical power lines and apparatus.
This machine is NOT electrically insulated.
• Do not exceed the unrestricted platform capacity shown on the platform.
• Do not operate this machine on soft or unstable ground.
• Operate this machine only on a flat level surface.
Death or serious injury can result from not complying to the following safety rules.
0072541
0182236
• Perform the PRESTART INSPECTION, in the Operator's Manual, prior to each work shift.
• Platform occupants MUST wear fall restraint attached to lanyard anchor points provided.
• In case of emergency, depress EMERGENCY STOP button. Pull out to reset.
• Do not use boom to lift or push this machine.
• Move controls slowly and deliberately to avoid jerky and erratic platform movement.
0261168
0261168 or 0260863
026116 8
lb
kg
This ov erride must only be used when a ll
controls are relea sed and in the neutral
position. If a zero or neutral state c annot be
achieved, depress the emergenc y stop and
obtain assistance at the lower con trols.
WARNING
OVE RRIDE
NOR MAL
OPE RATION
OVERRIDE O PERATION
When machin e is stopped
due to activa tion of the
Snorkel Guar d system or
overload, im mediately
depress the e mergency
stop, relea se the foot swit ch
and all contr ols. Perform a n
assessmen t of the situati on
which cause d the system
to activate .
1.
If it is determi ned that all
controls ar e released and
operation c an proceed,
return the eme rgency stop
to the on positi on and
activate th e override swi tch.
2.
Activate th e foot switch.
3.
Activate th e necessary
functions t o move the
platform aw ay from the
obstacle th at caused the
Snorkel Gu
ard activat ion,
or if due to an over load
fault, retr act the booms
then lower in a sa fe
condition .
4.
Assess the ma chine for
any damage. If d amage
occurred, r eturn to the
stowed posit ion, exit the
unit and perfo rm a
thorough ins pection
before retu rning
to service.
5.
To Next Page
Loading...
