A46JRT – 0260996
Appendix C – Inspection Checklists
Item Inspect For P/F/R
Operator’s Manual In place, all pages readable and intact
Engine
Oil level Between full and add marks
Coolant Proper fluid level
Radiator Cap tight, good condition and clean
Fuel tank and line Tank full, cap in place and tight/no leaks
Electrical System
Battery Condition and charged for proper operation
Battery fluid level and terminals Proper level/clean, connectors tight
Cables and wiring harness No wear or physical damage
Hydraulic System
Fluid level Between full and add marks
Fluid filter Verify operation in the green zone
Hoses, tubes, and fittings No leaks
Cold weather warm-up Proper operation
Tires
Air filled Good condition, proper inflation
Foam filled Good condition
Wheels All wheel lug nuts present and properly torqued
Lower Control Station
Operating controls Proper operation
Emergency stop and emergency power Shuts off lower controls/proper operation
Flashing Light Proper operation
Structures
Weldments – Chassis, turntable, booms, platform, etc. Welds intact, no damage or deformation
Slide pads In place, no damage or deformation
Fasteners In place and tight
Upper Control Station
Guardrail system and fall protection anchors Welds intact, no damage or deformation
Operating controls Proper operation
Emergency stop and emergency power Shuts off upper controls/proper operation
Horn Sounds when activated
Snorkel Guard Proper operation
Electrical power outlet – GFCI Proper operation
Level Sensor Sounds tilt alarm
Drive Motion Alarm Sounds when machine is driven
Sandblast Protection Kit In place and proper operation
Air Line to Platform No damage or deformation, caps in place
Drive and Working Lights No damage or deformation, proper operation
Tow Kit In place, no damage or deformation
Placards and Decals In place and readable
Prestart Inspection Checklist
Performed by: Date:
Model Number: Serial Number:
Maintenance Table Key: P = Pass, F = Fail, R = Repaired
To Next Page
Loading...
