Snorkel S1930E - Electrical System; Hydraulic System; Placards and Decals

Chapter 3 – Safety
S1930E/S1932E/S2632E – 1360460 9
wheel load and drive/lift level sensor interlock informa-
tion. Raise the platform only when the aerial platform is
on level ground.
Danger
The aerial platform can tip over if it becomes unstable.
Death or serious injury will result from a tip-over ac-
cident. Do not drive or position the aerial platform
for elevated use near any drop-off, hole, slope, soft
or uneven ground, or other tip-over hazard. Do not
raise the platform outdoors in wind speeds above 28
mph (12.5 m/s).
Do not operate the aerial platform within 4′ (1.2 m) of any
drop-off or hole.
Do not raise the platform in winds above 28 mph (12.5
m/s). Do not add anything to the aerial platform that will
increase the wind loading such as billboards, banners,
ags, etc.
Never operate the aerial platform without all parts of the
guardrail system in place and the safety gate closed.
Make sure that all protective guards, cowlings, and doors
are securely fastened.
Do not exceed the platform capacity nor the platform-
extension capacity as indicated on the platform rating
placard on the platform. Do not carry loads that extend
beyond the platform guardrails without prior written con-
sent from Snorkel.
Do not operate the aerial platform from trucks, trailers, rail-
way cars, oating vessels, scaffolds, or similar equipment
unless the application is approved in writing by Snorkel.
Do not use the aerial platform as a crane, hoist, jack or
for any purpose other than to position personnel, tools,
and materials.
Do not climb on the guardrails or use ladders, planks,
or other devices to extend or increase the work position
from the platform.
Take care to prevent rope, electrical cords, and hoses,
etc., from becoming caught in or on the aerial platform.
If the platform or scissors structure becomes caught
on an adjacent structure or other obstacle and is
prevented from normal motion, reverse the control to
free the platform.
If control reversal does not free the platform, evacuate
the platform before attempting to free it.
It is best not to transfer from the platform to another
structure or from the structure to the platform, unless
that is the safest way to do the job. Judge each situation
separately taking the work environment into account. If
it is necessary to transfer from the platform to another
structure the following guidelines apply:


1. If you are using a fall restraint, transfer your anchor-
age from one structure to the other before stepping
across.
2. Remember that you might be transferring to a struc-
ture where personal fall arrest is required.
3. Use the platform entrance, do not climb over or
through the guardrails.
Electrical System
Charge the batteries in a well-ventilated area free of
ame, sparks, or other hazards that might cause re or
explosion.
Do not operate any of the aerial platform functions while
the battery charger is plugged in.
Warning
Batteries give off hydrogen and oxygen that can com-
bine explosively. Death or serious injury could result
from a chemical explosion. Do not smoke or permit
open ames or sparks when checking the batteries.
Battery acid can damage the skin and eyes. Serious
infection or reaction could result if medical treatment
is not given immediately. Wear face and eye protec-
tion when working near the batteries.
Batteries contain sulfuric acid that can damage your
eyes or skin on contact.
Wear a face shield, rubber gloves, and protective
clothing when working around batteries.
If acid contacts your eyes, ush immediately with clear
water and get medical attention.
If acid contacts your skin, wash off immediately with
clear water.
Hydraulic System
The hydraulic system contains hoses with hydraulic uid
under pressure.
Danger
Hydraulic uid escaping under pressure can have
enough force to inject uid into the esh. Serious
infection or reaction will result if medical treatment is
not given immediately. In case of injury by escaping
hydraulic uid, seek medical attention at once.
Do not place your hand or any part of your body in front
of escaping hydraulic uid. Use a piece of cardboard or
wood to search for hydraulic leaks.
Placards and Decals
The aerial platform is equipped with placards and decals
that provide instruction for operation and accident preven-
tion. Do not operate the aerial platform if any placards or
decals are missing, damaged, or illegible.



