PROPER USE OF SAFETY PROP
TO STORE SAFETY PROP
1. Remove all material from platform.
2. Raise platform until the open height is wide
enough to position the safety prop.
3. Place safety prop in the proper position.
4. Remove hands and arms from scissors area.
5. Lower platform until scissors are supported by
safety prop.
1. Raise platform until the open height is wide
enough to position the safety prop.
2. Place the safety prop in the storage position.
0361259
Death or serious injury
might result if safety prop
is not used and/or
properly positioned. Use
safety prop at all times
when servicing machine
with platform raised.
Proper position for safety prop use
DEATH OR SERIOUS INJURY CAN RESULT FROM TIPPING OVER.
TO KEEP FROM TIPPING THIS MACHINE OVER FOLLOW THESE RULES.
OTHER ACTIONS CAN ALSO CAUSE THIS MACHINE TO TIP OVER
NOTE: STUDY THE OPERATOR'S MANUAL
BEFORE OPERATING THIS MACHINE.
0372000
DO NOT
DO NOT
DO NOT
DO NOT
DO NOT
override s afety devices.
overload t he machine.
stand or sit on guar drails.
attach r opes or chains to guardrails.
carry loads outside the railing or use
as a crane.
DO NOT use this machine without the railings and the
entry gate, chain or bar in place. You could fall
out and hurt or kill yourself.
DO NOT use this machine if it is not working r ight, or if
any part of it is damaged, wor n, or missing.
An acciden t could cause injury or death.
DO NOT
DO NOT
let an untrained or unauthorized person us e this
machine. When you leave t he machine unattended,
remove the key, or turn off the battery switch on the base
of the machine and lock the batter y switch in the off
position.
replace components critical to machine stability, such as
batteries and wheel equipment, with lighter weight or
DO NOT
DO NOT
DO NOT
ride pl atform whil e machine i s on a truck, fork lift
or other device.
use ladder, scaffold, or o ther means to increase
size or platform height.
use with damaged tires or wheels.
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON
SOFT OR UNEVEN
SURFACES
DO NOT RAISE OR DRIVE AN ELEVATED
PLATFORM ON A
SLOPE
GO NO CLOSER THAN 4 feet (1.2m)
to ANY DROP OFF
OR HOLE
4 FT
OK
1.
3.2.
ALARM MEANS TIPOVER DANGER!
LOWER PLATFORM IMMEDIATELY
TO AVOID
TIPOVER HAZARDS
USE ON
FLAT, LEVEL, AND
SOLID SURFACES
ONLY
4 FT
OK
ELECTRICAL SHOCK CAN KILL YOU
This machine is not electrically insulate d. Maintain 10 feet minimum
clearance f rom electr ical power lines and apparatus.
Allow for platform sway, rock, or sag. If voltage is 300 V to 50 kV stay at lea st
10 feet (3.1m) away. If voltage is more than 50 kV talk with your supervisor or
read the Operator's Ma nual on this machine for s afe distances.
This machine will not protect you from shock.
DO NOT RAISE THE PLATFORM
IN WIND ABOVE 28 MPH (12.5 M/S)
To Next Page
Loading...
