Chapter 12 – Troubleshooting
50 S1930E/S1932E/S2632E – 1360460
Symptom Possible Cause Corrective Action
Only slow drive speed works. Platform elevated above 7 to 8 feet
(2.1 to 2.4 m).
Normal operation, lower platform to drive
machine at faster speed.
Drive range selector is in the low
(turtle) position – S2632E only.
Place the switch in the high (rabbit) posi-
tion.
Machine will not steer. Joystick interlock switch not en-
gaged.
Engage the interlock switch before operat-
ing the steer switch.
Wheels won’t turn when winch-
ing or pushing.
Brakes are engaged. Manually release the brakes using the
hand pump.
Free-wheeling valve closed. Fully open free-wheeling valve.
Tilt alarm does not work. Platform is not raised more than
6′ (1.8 m).
Normal operation. The tilt alarm is not
active until the platform is raised more
than 6′ (1.8 m).
Battery charger power on LED
does not indicate a reading
when charging batteries.
No source of power. Make sure power source is plugged in
and turned on.
Faulty batteries or charger. Stow the machine and do not operate until
repairs are made.
Hydraulic uid temperature of
160°F (71°C) or more.
Prolonged driving or platform opera-
tion.
Stop operation until uid cools.
High pressure uid return to reservoir
caused by kinked or twisted hose.
Remove the kink or twist from the hose.
Let uid cool before resuming operation.
Hydraulic system component failure. Stow the machine and do not operate until
repairs are made.
Severe hydraulic leak.
Failure of hose, tube, tting, seal, etc.
Stow the machine and do not operate until
repairs are made.
To Next Page
Loading...
