4
UNPACKING AND INSTALLATION
4.1 UNPACKING.
Remove the UPS and all the accessories that come with it (cables, CD-ROMs, etc) from its packing case.
It is always advisable to keep the original packaging that has been specially designed for safe transport, in case the
unit has to be moved again.
4.2 ENVIRONMENTAL REQUIREMENTS FOR INSTALLATION.
Please check what follows before installing the UPS.
Netys has been designed for use in closed environments.•
Place the UPS on a at and stable surface, in a ventilated environment away from heat sources and exposure to •
direct sunlight.
Keep ambient temperature between 0 °C and 40 °C and humidity less than 90% (non-condensing); the best tem-•
perature to guarantee the longest battery life is 15-20 °C.
Ensure that the environment where the UPS will be installed is not dusty, and leave a space of at least 20 cm •
around it to allow for adequate ventilation and access to the rear panel.
Make sure not to place the UPS or any other heavy object on the cables.•
Check that the voltage and frequency preset for operation is right for your electrical power supply looking the data •
can be found on the data plate.
Use only the manufacturer-supplied or recommended cables and accessories for connections to the RS232/USB •
serial interface.
It is recommended to charge the batteries for 8 hours the rst time the unit is used.
WARNING!
The lateral brackets supplied MUST be mounted on models designed for installation in standard
19” cabinets.
To Next Page
Loading...
Need help?
General