12
USER MAINTENANCE GUIDE
GO-KART RECEPTION
Keep go-kart in original configuration
Use spare parts of Sodikart origin
This document can not be reproduced or released without the Sodikart authorization.MAN.GT4.EN.01
Start up with a driver on the go-kart
• Check that maintenance of the go-kart is done. Each
maintenance instructions were checked and modified
if it is required.
• Place the driver on the go-kart.
Legend
6 Throttle pedal
• Switch the ON/OFF button (1) to ON.
• Pull the starter lever (2) to the left.
• To feed petrol to the engine, push the petrol valve (3)
to the right.
• Ask to push the throttle pedal (6) lightly.
• Yank the starter pull cord (5).
Start up with no driver on the go-kart
• Check that the go-kart you plan to start is operational
(all instructions on the maintenance sheet have been
checked and all necessary repairs carried out).
• Switch the ON/OFF button (1) to ON.
• Pull the starter lever (2) to the left.
• To feed petrol to the engine, push the petrol valve (3)
to the right.
• Push the throttle lever (4) lightly
• Yank the starter pull cord (5).
Check with the throttle lever that the throttle cable have
a play (3).
If the engine does not start, repeat the handling.
Repeat the handling often can drown the engine.
Push the throttle pedal at maximum when you start
the engine ,may lead to a serious or even fatal injury.
The engine is source of heat which presents a risk
of burn for the driver, Make sure that protections
are correctly
secured and in a good state.
The engine is a rotation part which presents a risk of
serious or even fatal injury, by winding of long hairs or
loosing clothes.
A throttle cable too tight, may accelerate the go-kart
without driver, and may lead to a serious or even fatal
injury.
Push the throttle pedal with the foot and yank on the
recoil together, may lead to a serious or even fatal
injury.
To Next Page
Loading...
Need help?
General
