37
USER MAINTENANCE GUIDE
ADJUSTMENT AND MAINTENANCE OF THE CHASSIS
This document can not be reproduced or released without the Sodikart authorization.MAN.GT4.EN.01
Keep go-kart in original configuration
Use spare parts of Sodikart origin
Tyres
• Take particular care when fitting tyres that they rotate
in the right direction. Follow the directional arrows on
the tyre wall.
• Check for tyre wear with the indicators in the tread.
One must always be able to see them. Tears or tread
separation must not be found.
• Before each session check tyre pressures:
- Duro tyre:
- Itaka tyre:
Braking
• Make sure before all sessions that the braking system
is working properly.
• Brake fluid should not be black. Drain and change
black fluid. Check levels.
• Ensure that brake pads are correctly fitted and do not
fall below the minimum thickness of 8 mm (4 mm
lining + 4 mm steel support).
• Brake hoses must not show any leaks at connection
points. Replace if damaged.
Chassis cleaning
• Clean your chassis at least once a week.
• Use only go-kart cleaner WD40 (ref. LU833.004).
Front 1.5 to 1.7 bar
Rear 1.7 to 1.9 bar
Front 1.5 to 1.7 bar
Rear 1.7 to 1.9 bar
Cleaning the go-kart with a pressure washer can lead to
fast deterioration of certain go-kart components (e.g.
stickers, bearings, etc.).
After each cleaning, check that the go-kart components
are in good condition. Follow the recommendations for
use of your pressure washer when washing your go-
kart.
To Next Page
