Sofarsolar SOFAR 60KTLX-G3 - Updating Inverter Software

SOFAR 60-80KTLX-G3 User manual
Copyright © Shenzhen SOFARSOLAR Co., Ltd.
48
3.SystemInfo
------Long press DOWN button
1.Inverter Type
11.Reflux Enable
2.Serial Number
12.Reflux Power
3.General Soft Version
13.DRM0
4.General Hard Version
14.DRMn
5.Country Code
15.MPPT Scan
6.Safety Software Version
16.Force Control
7.Safety Hardware Version
17.Power Derate
8.Modbus Address
18.PCC Select
9.Input Mode
19.Reflux Mode
10.Remote State
The user enters the main menu by long pressing the DOWN button, short press and
turns the page to select menu contents, then long press the button to enter "3.
SystemInfo". Turning the page down can select the system information to view.
(D)System Time
Long press the button and short press the button to turn the page in the standard user
interface to enter into “4.Display Time”,then long press the button to display the
current system time.
(E)Software Update
Enters the main menu, short press to select "5. Software Update", then long press
the button to enter. Short press the UP or DOWN button to enter the number, long
press DOWN button to confirm the number, enter the password.
User can update software by USB flash drive , SOFARSOLAR will provide the new
update software named ‘firmware’ for user if it is necessary. The user needs to copy
the upgrade file to the USB flash drive.
7.4. Updating Inverter Software
SOFAR 60~80KTLX-G3 inverter offer software upgrade via USB flash drive to
maximize inverter’s performance and avoid inverter operation error caused by
software bugs.
Step 1：Turn off AC circuit breaker and DC switch, remove the communication
board cover as below figure. If the RS485 line has been connected, please release