Language
1. Select the Language option to set the language in which the LCD should display.
2. Confirm your language selection in the confirmation screen: Toggle to YES and
press Enter.
Communication
1.
Select the Communication option to define and configure:
The communication option used by the inverter to communicate with the
SolarEdge monitoring platform
The communication option used to communicate between multiple SolarEdge
devices or other external non-SolarEdge devices, such as energy meters or
loggers.
2. Select Server to set which communication method is used to communicate between
devices and the monitoring platform. Refer to
Setting Up Communication to the
Monitoring Platform
on page 65 for a full description of these communication
options.
NOTE
The Server menu shows only the communication options installed in the
inverter.
The following shows a hierarchical tree of the menu options in the Communication
menu.
For detailed information about all the configuration options, refer to the
Communication Options Application Note
, available on the SolarEdge
website at http://www.solaredge.com/files/pdfs/solaredge-
communication_options_application_note_v2_250_and_above.pdf.
Communication
(1)
,
(2)
:
S e r v e r < L A N >
L A N C o n f
R S 4 8 5 – 1 C o n f < S >
Z i g B e e C o n f < S >
W i - F i C o n f < N / A >
C e l l u l a r C o n f
G P I O C o n f < M T R >
(1)
If ZigBee is connected, the Wi-Fi Conf menu is not displayed. If ZigBee is not connected, ZigBee Conf and
Wi-Fi Conf are both displayed with <N/A> and their menus are not accessible.
(2)
When using the SolarEdge GSM products, RS232 Conf menu is unavailable.
Three Phase System MAN-01-00507-4.2
52 Configuration Menu Options
To Next Page
Loading...
Need help?
General