27
Preparation before Installation
5.2 Tools Requirement
Installation tools include but are not limited to the following recommended ones. If
necessary, use other auxiliary tools on site. The following tools must all comply with
regulatory requirements.
Safety gloves
Torque wrench
Safety boots
Heat gun
Safety goggles
Crimping tool
Spirit level
Anti-dust mask
Crimping tool for ferrules Wire cutter
Marker
Measuring tape Utility knife
Wire stripper Crimping tool for RJ45
Crimping tool for
PV terminals
Diagonal pliers
Rubber mallet
Ø2 mm Flat-head
screwdriver
Torque screwdriver
(Flat-head: M2)
(Phillips head: M2.5 / M3 / M5)
Hammer drill
(drill bit:
Ø
12 mm)
Multimeter
(≥ 1100 V DC
)
Heat shrink tubing
(
Ø
8 mm)
To Next Page
Loading...
