61
Electrical Connection
Figure 8-39 Installing RJ45 terminal to the cable fixture
Step 5: Connect the assembled connector to COM 1 terminal. Make sure the cable fixture
part is well inserted into the slot of terminal. You will hear an audible "Click" if
it is connected securely. Lightly pull the cable backward for double check its
connection.
Step 6: Secure the assembled connector on COM 1 terminal.
a. Install the connector enclosure back into the COM 1 terminal.
b. Install the cable support sleeve into the enclosure.
c. Tighten M3 screw to secure it. (Torque: 0.4± 0.1 N·m)
d. Clockwise tighten the swivel nut to finish the COM 1 wiring connection.
To Next Page
Loading...
