Cleaning and maintenance
44/78
– Turn the lamp 90°.
The lettering must be oriented towards the outside (i.e. towards the tan-
ning room or towards the user).
7.8.2 Starter
Replace faulty starters immediately.
You can recognize a faulty starter by the blackened ends of the lamps or
when the lamps can no longer be started.
Operating a lamp with a faulty starter significantly shortens its service life. The
lamp loses power and may begin to flicker under certain circumstances.
The starters are located in either one of the two lamp sockets or are visible
when the lamps are removed.
– Turn 90° and carefully remove from the socket.
7.8.3 High pressure lamps and filter panels
WARNING!
Danger of burns from hot lamps and device parts!
If the tannin
switched off
and opened, lamps and housing parts may be hot.
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
WARNING!
Fire hazard due to overheated lamps!
Non-approved high pressure lamps can explode. Hot lamp
components can set other parts on fire. People can be killed
or severely injured due to smoke inhalation and fire.
– Only fit the high pressure lamps specified by the manu-
facturer.
– Clean the inside of the device regularly. Dust particles
are flammable!
To Next Page
Loading...
