Cleaning and maintenance
48/78
– Remove the two upper low pressure lamps in the canopy so that you can
thenaccess the facial tanner's low pressure lamp starter.
Replacing the lamps: see page 43.
Replacing the starters: see page 44.
UV high pressure lamps and filter panels: see page 44.
The assembly is the same process in reverse order.
When assembling the device please note:
– Support the canopy panel with one hand so that it does not fall down.
– Replace and retighten the screws. Replace the middle screw first and
then the outer screws.
7.12 Cleaning or replacing the UV lamps
and filter panels in the shoulder
tanner
WARNING!
Danger of burns from hot lamps and device parts!
If the tanning device was operated before being switched off
and opened, lamps and housing parts may be hot.
– Before replacing lamps or other spare parts, wait until
lamps and metal parts of the device have cooled down
sufficiently.
– Opening the bed base: see page 41.
To Next Page
Loading...
