OPERATING THE EQUIPMENT
DAS Firmware Upgrade Procedure
STEP 9
9 On the DAS page click connect.
12 Click Select.
8 Open the DAS software by double clicking on the icon.
If only one Comms Port connection is available on the PC, then close the WTT
program by selecting Exit Program, then disconnect the CPU connection from the
Comms Port and replace it with the DAS connection on the Dual Test Cable.
2 NOTE
10 A DAS Comms selection window will open.
11 Choose the correct COMMS port for the DAS connection, from the drop down
selection.
To Next Page
Loading...
