EQUIPMENT SUPPLIED
STEP 2
This Quick Start Guide gives instruction on how to upgrade the HOST or DAS firmware
used in Type 8300 Transponders, using the Dual Test Lead.
The table below lists all transponders this Quick Start Guide is relevant to and their
identifying colour band.
To enable the firmware upgrade process, a Dual Test Lead is supplied with the equipment.
If the correct test lead is not available, please contact Sonardyne for product support.
Refer to Step 1 for details.
2 NOTE
This Quick Start Guide is for the upgrade of the 8300 Series Transponders, for
the upgrade of the 8300 Transceivers (Dunker 6 and RovNav 6) please refer to
the 8300 Transceiver Quick Start Guide - QSG-UP-8300-01 A0.
Transponder Number Transponder Type Colour Band
8300
8301
8305
8307
8308
Compatt 6
DPT(i)6
AMT
Modem
SLT
Make sure all Warnings and Caution labels on the equipment are read and
understood. Refer to the equipment manual for further information and assistance.
To Next Page
Loading...
