130 Appendix
Appendix
Troubleshooting chart (continued)
Symptoms Cause Remedy
The time code setting is not possible. At the recording, the ClipLink function is
set to on (meaning ClipLink shooting is
allowed) in menu 211, CONT is displayed
in the display window and the time code
generator is in the REGEN mode.
Only the REGEN mode can be used for
ClipLink shooting. If you will not perform
ClipLink shooting, set the ClipLink
function to oFF (see page 109).
The time code value does not advance
though the TC mode switch 1 or 2 is set
to the F-RUN or DATE/TIME.
Troubleshooting
To Next Page
Loading...
