4 Pressthecenterofthecontrolbutton.
The monitor returns to tile recording int_nnation display with the memorized
custom white balance setting retained.
• The custom white balance setting registered in this operation is effective
until a new setting is registered.
Role
• The message "Custom WB error" indicates that the value is beyond tile expected
range. (When the flash is used on a subject in close proximity or a subject with a
bright color is in tile li'ame.) If you register this value, the _=._ indicator turns yellow
on the recnrding inlormatinn display on the LCD monitor. You can shoot at this
point, but it is recommended that you set the white balance again to get a more
correct white balance value.
To call the customwhite balance setting
Fnbutton--+ [Whitebalance]--+ _=_(Custom) =
=a-
Note _.
regislered with the flash light taken into account. Take pictures with the flash in later =----"
shoolings.
i,
==
95
To Next Page
Loading...
