Sony Alpha SLT-A99 - DRO Bracket; Remote Cdr

114
Selecting the drive mode
Notes
• The RMT-DSLR1 Wireless Remote Commander (sold separately) cannot be used
for movie recording. Use the RMT-DSLR2 (sold separately).
• You can check the START/STOP operation of the RMT-DSLR2 by the light of the
self-timer lamp on the camera.
• When [MOVIE Button] is set to [Movie Mode Only], the START/STOP button on
the Remote Commander can be available only when the mode dial is set to Movie
(only for the RMT-DSLR2).
• Refer also to the operating instructions supplied with the Wireless Remote
Commander.
DRO Bracket
1 (Drive) button t (DRO Bracket) t Select the
desired setting with b/B on the multi-selector
• When Lo is selected, the image is recorded with DROLv1, Lv2, and Lv3,
and when Hi is selected, the image is recorded with DROLv1, Lv3, and
Lv5.
2 Adjust the focus and shoot the subject.
Remote Cdr.
1 (Drive) button t (Remote Cdr.)
2 Focus on the subject, point the transmitter of the Wireless
Remote Commander to the remote sensor, and shoot the
image.