I
About AAC files
• AAC, which stands for Advanced Audio Coding,
is
a music file compression format standard.
It
compresses audio
CD
data to approximately
1/1
1*
of
its original size.
• AAC tag
is
126 characters.
• When naming an AAC file, be sure to add the file
extension
".m4a"
to the file name.
• During playback
or
fast-forward/reverse
of
a VBR
(variable bit rate) AAC file, elapsed playing time
may not display accurately.
* only for 128 kbps
Note on AAC
Playback
of
a copyright-protected file
is
not supported.
About ATRAC CD
ATRAC3plus format
ATRAC3, which stands for Adaptive Transform
Acoustic Coding3,
is
audio compression
technology.
It
compresses audio
CD
data to
approximately 1/10
of
its original size.
ATRAC3plus, which
is
an extended format
of
ATRAC3, compresses the audio
CD
data to
approximately 1/20
of
its original size.
The
unit
accepts both ATRAC3 and ATRAC3plus format.
ATRAC CD
ATRAC
CD
is
recorded audio
CD
data which
is
compressed to ATRAC3
or
ATRAC3plus format
using authorized software, such as SonicStage 2.0 or
later,
or
SonicStage Simple Burner.
•
The
maximum number of:
- folders (groups): 255
- files (tracks):
999
•
The
characters for a folder/file name and text
information written by SonicStage are displayed.
For details
on
ATRAC CD, see the SonicStage
or
SonicStage Simple
Burner
manual.
Note
Be sure
to
create the ATRAC CD using authorized
software, such
as SonicStage
2.0
or
later,
or
SonicStage Simple Burner
1.
0
or
1.
1.
For customers in USA, please visit the following
site for further information:
http://www.xplodsony.com
If
you have any questions
or
problems concerning
your unit that are not covered in this manual, consult
your
nearest Sony dealer.
Maintenance
"v'
.
Replacing the lithium battery of the
card remote commander
Under normal conditions, the battery will last
approximately
I year. (The service life may be
shorter, depending on the conditions
of
use.)
When the battery becomes weak, the range
of
the
card remote
commander
becomes shorter. Replace
the battery with a new
CR2025
lithium battery. Use
of
any other battery may present a risk
of
fire
or
explosion.
Notes on the lithium battery
• Keep the lithium battery out
of
the reach
of
children.
Should the battery be swallowed, immediately
consult
a doctor.
• Wipe the battery with
a dry cloth
to
assure a good
contact.
• Be sure
to
observe the correct polarity when
installing the battery
• Do
not
hold the battery with metallic tweezers,
otherwise
a short-circuit may occur.
WARNING
Battery
may
explode
if
mistreated.
Do
not
recharge,
disassemble,
or
dispose
of
in
fire.
20
About iPod
This unit can
be
used with the dock connector type
iPod, iPod photo, iPod mini and iPod nano with the
following software versions. All other versions
earlier than listed are not guaranteed.
- Third-generation iPod: Ver.2.3.0
- Fourth-generation iPod: Ver.3.I.l
- Fifth-generation iPod: Ver.I.2
- iPod photo: Ver.I.2.1
-iPod
mini: Ver.IA.I
- First-generation iPod nano: Ver.I.3
- Second-generation iPod nano:
Ver.l.l
(video function
of
fifth-generation iPod and
photo function
of
iPod photo are not supported).
Fuse replacement
When replacing the fuse, be
sure to use
one
matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse.
If
the fuse
blows again after replacement,
there may be an internal
malfunction. In such a case,
consult your nearest Sony
dealer.
~
~
Fuse (10
A)
To Next Page
Loading...
