•
22
Optional
accessories/equipment
*:
Marine remote commander: RM-X55M,
RM-XIIM
BUS cable (supplied with an RCA pin cord):
RC-61
(I m), RC-62 (2
m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T7OMX, CDX-T69
Source selector: XA-C40
AUX-1N
selector: XA-300
for
CDX-H905IP
HD
Radio™
tuner: XT-IOOHD
* Accessories/equipment other than the marine
remote commander RM-X55M/X11
M are not
waterproof. Do not subject them
to
water.
Your
dealer
may
not
handle
some
of
the above listed
accessories. Please ask the
dealer
for detailed
information.
US
and
foreign
patents
licensed from
Dolby
Laboratories.
MPEG
Layer-3 audio
coding
technology and
patents licensed from
Fraunhofer
US
and
Thomson.
This
product
is protected by certain intellectual
property rights
of
Microsoft
Corporation. Use
or
distribution
of
such
technology
outside
of
this
product
is prohibited
without
a license from
Microsoft
or
an
authorized
Microsoft
subsidiary.
Note
This unit cannot
be
connected
to
a digital preamplifier
or
an equalizer which is Sony BUS system compatible.
Design
and
specifications are subject to change
without notice.
• Halogenated flame retardants are not used
in
the
certain printed wiring boards.
• Halogenated flame retardants are not used in
cabinets.
• Packaging cushions are made from paper.
, ,
Troubleshooting
.
The
following
checklist
will help you
remedy
problems
you may
encounter
with
your
unit.
Before
going
through the
checklist
below,
check
the
connection
and
operating
procedures.
General
No
power
is
being
supplied
to
the unit.
• Check the connection. If everything
is
in
order, check
the fuse.
o If the unit
is
turned off and the display disappears,
it
cannot be operated with the remote commander.
-Turn
on the unit.
The
power
antenna (aerial)
does
not
extend.
The power antenna (aerial) does not have a relay box.
No
sound.
• The volume
is
too
low.
• The
ATT
function
is
activated, or the Telephone
ATT
function (when the interface cable
of
a telephone
is
connected
to
the
ATT
lead)
is
activated.
o The position
of
the fader control "FAD"
is
not set for
a 2-speaker system.
o The CD changer
is
incompatible with the disc (MP31
WMA/AACIATRAC
CD).
- Play back with a Sony MP3 compatible CD
changer, or this unit.
No beep
sound.
o The beep sound
is
canceled (page 16).
•
An
optional power amplifier
is
connected and you are
not using the built-in amplifier.
The
contents
of
the
memory
have been erased.
o The RESET button has been pressed.
- Store again into the memory.
o The power supply lead or battery has been
disconnected.
• The power supply lead
is
not connected properly.
Stored
stations
and
correct
time
are erased.
The fuse
has
blown.
Makes
noise
when
the
position
of
the
ignition
is
switched.
The leads are not matched correctly with the boat's
accessory power connector.
During
playback
or
reception,
demonstration
mode
starts.
If
no operation
is
performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
-Set
"DEMO-OFF" (page 16).
The
display
disappears from/does
not
appear
in
the
display
window.
• The dimmer
is
set "DIM-ON" (page 16).
o The display disappears if you press and hold
(OFF).
- Press and hold
(OFF)
on the unit until the
display appears.
The
Auto
Off
function
does
not
operate.
The unit
is
turned on. The Auto Off function activates
after turning off the unit.
- Turn off the unit.
To Next Page
Loading...
