Preset tuning is not possible
l
Store the correct frequency in the memory
l
The broadcast signal is too weak
The stations cannot be received
The sound is hampered by noises
l
Connect a power antenna control lead
(blue) or accessory power supply lead
(red) to the power supply lead of a car’s
antenna booster (Only when your car has
built-in FM/AM antenna in the rear/side
glass )
l
Check the connection of the car antenna
l
The auto antenna will not go up
+ Check the connection of the power
antenna control lead
l
Check the frequency
Automatic tuning is not possible
l
The local seek mode is set to “ON ‘I
+ Set the local seek mode to “OFF”
(page
16)
l
The broadcast signal is too weak
4 Perform manual tuning
The “ST” indication flashes
l
Tune in the frequency accurately
l
The broadcast signal is too weak
-+ Set to the monaural reception mode
(page
16)
A program broadcast in stereo is heard in
monaural
The unit is in monaural reception mode
-P Cancel monaural reception mode
(-me
16)
Interference occurs during FM reception
The wide mode is selected
+ Set the IF mode to “IF AUTO” (page 16)
Error displays/Messages
The following indications will flash for about 5
seconds, and an alarm sound will be heard
ERROR
l
A CD is dirty or inserted upside down
-+ Clean or insert the CD correctly
l
A CD cannot play because of some
problem
---c Insert another CD
HI TEMP
The ambient temperature is more than 50°C
(122°F)
+ Wait until the temperature goes down
below 50°C (122’F)
RESET
The CD unit cannot be operated because of
some problem
+ Press the RESET button on the unit
If these solutions do not help improve the
situation, consult your nearest Sony dealer
L SEEK +/-
The Local Seek mode is on during automatic
tuning (page 11)
I
LL LLI or I-7 -r-i’
You have reached the beginning or the end
of the disc and you cannot go any further
22
To Next Page
