Error displays/Messages
CHECKING
The unit
is
confirming the connection
of
a USB device.
- Wait until confirming the connection
is
finished.
ERROR*1
• The disc is dirty or inserted upside down.
*2
- Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play due
to
a problem.
- Insert another disc.
• USB device was not automatically recognized.
- Reconnect it again.
• Press
~
to remove the disc.
FAILURE (Illuminates until any button
is
pressed.)
The connection of speakers/amplifiers
is
incorrect.
- See the installation/connections manual
of
this
model to check the connection.
FAILURE (Illuminates for about 1 second.)
When the SAT tuner
is
connected, storing an SAT
radio channel into a preset failed.
- Be sure to receive the channel that you want
to
store, then try it again.
HUB
NOSUPRT
USB hub
is
not supported on this unit.
LOAD
The CD changer
is
loading the disc.
- Wait until loading is complete.
L.
SEEK
+/-
The local seek mode
is
on during automatic tuning.
NO DEV (No Device)
(
SOURCE)
is
selected without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
- Be sure to connect a USB device and USB cable.
NO DISC
The disc is not inserted in the
CD
changer.
- Insert discs in the
CD
changer.
NO MAG
The disc magazine is not inserted in the
CD
changer.
- Insert the disc magazine
in
the CD changer.
NO MUSIC
The disc or USB device does not contain a music file.
- Insert a music
CD
in this unit or an MP3 playable
CD changer.
-Connect
a USB device with a music file
in
it.
NO NAME
A disc/album/artist/track name
is
not written
in
the
track.
OFFSET
There may be an internal malfunction.
-Check
the connection.
If
the error indication
remains on in the display, consult your nearest
Sony dealer.
OVERLOAD
USB device
is
overloaded.
- Disconnect the USB device, then change the source
by
pressing
(§QQffi~.
- Indicates that the USB device is out
of
order, or
an
unsupported device is connected.
READ
The unit is reading all track and album information on
the disc.
- Wait until reading
is
complete and playback starts
automatically. Depending on the disc structure, it
may take more than a minute.
RESET
The CD unit, CD changer or USB device cannot be
operated due to a problem.
- Press the RESET button (page 6).
USB NO SUPRT (USB Not Support)
The connected USB device is not supported.
- For details on the compatibility
of
your USB
device, visit the support site.
"L
L L
L"
or
",
I I I "
During reverse or fast-forward, you have reached the
beginning or the end
of
the disc and you cannot go any
further.
" "
The character cannot be displayed with the unit.
*1
If
an
error
occurs during playback
of
a
CD,
the disc
number
of
the
CD
does
not
appear
in the display.
*2 The disc
number
of
the disc causing the
error
appears in the display.
If
these solutions
do
not help improve the situation,
consult
your
nearest Sony dealer.
If
you take
the
unit to be repaired
because
of
CD
playback
trouble, bring the disc that
was
used at the _
time the
problem
began.
25
To Next Page
Loading...
