Sony DFS-700 - Page 157

Appendixes
Appendixes A-19
Effect control parameters (continued)
Pattern
No.
Effect type and adjustable parameters
2854 3D wave
2855 F1: Amount of X-axis rotation (Rot_X = –100 to +100)
F2: Amount of Y-axis rotation (Rot_Y = –100 to +100)
F3: Amount of Z-axis rotation (Rot_Z = –100 to +100)
F4: Perspective (Pers = 0 to 100)
F5: Direction of wave modulation (Angle = 0 to 99)
F6: Amplitude of wave modulation 1 (Amp1 = 0 to 100)
F7: Frequency of wave modulation 1 (Freq1 = 0 to 100)
F8: Phase of wave modulation 1 (Phase1 = 0 to 99)
F9:Speed of auto change in phase of wave modulation 1 (Speed1 =
–100 to +100)
F10: Position of light source (Light = –100 to +100)
F11: Amplitude of wave modulation 2 (Amp2 = 0 to 100)
F12: Frequency of wave modulation 2 (Freq2 = 0 to 100)
F13: Phase of wave modulation 2 (Phase2 = 0 to 99)
F14: Speed of auto change in phase of wave modulation 2 (Speed2 =
–100 to +100)
X/Y/Z: Location, enlargement, and reduction of the pattern
2856 3D flag
2857 F1: Amount of X-axis rotation (Rot_X = –100 to +100)
F2: Amount of Y-axis rotation (Rot_Y = –100 to +100)
F3: Amount of Z-axis rotation (Rot_Z = –100 to +100)
F4: Perspective (Pers = 0 to 100)
F5: Position of pole (POLE = RIGHT/LEFT)
F6: Amplitude of wave modulation (Amp = 0 to 100)
F7: Change in direction of waving (Swing = 0 to 100)
X/Y/Z: Location, enlargement, and reduction of the pattern
2860 Kaleidoscope
F1: Size of repetition (Size = 0 to 100)
F2: Amount of auto rotation (RotSpd = –100 to +100)
2865 3D crystal
F1: Amount of auto repetition in X-axis rotation (Swng_X = 0 to 100)
F2: Amount of auto repetition in Y-axis rotation (Swng_Y = 0 to 100)
F3: Amount of auto rotation on Z-axis (Spd_Z = –100 to +100)
F4: Width of beveled edge (Width = 0 to 100)
F5: Height of beveled edge (Hight = 0 to 100)
X/Y/Z: Location, enlargement, and reduction of the pattern
2866 Mirror cube
F1: Amount of auto rotation on X-axis (Spd_X = –100 to +100)
F2: Amount of auto rotation on Y-axis (Spd_Y = –100 to +100)
F3: Amount of auto rotation on Z-axis (Spd_Z = –100 to +100)
X/Y/Z: Location, enlargement, and reduction of the pattern
2870 3D object effects
F1: Mapping mode (MapMod = POINT/FACE1/FACE2)
(continued)