Copyingimagesto yourcomputer
This section describes the process using a
Windows computer as an example.
You can copy images fi'om the camera to
your computer as follows.
Foracomputerwitha"Mem0ryStick"
sl0t
Remove the "Memory Stick" from the
camera and insert the "Memory Stick" into
the "Memory Stick" slot of the computer,
then copy the images.
Fora computerwithouta "Memory
Stick"slot
Follow Stages l through 5 on pages 58 to
62 to copy images.
• Screens when copying images on a "Memory
Stick" to a computer are used as examples.
• A driver is snliware that enable equipment
connected to the computer to operate properly.
• When using Windows XP, start from Stage 2.
• When "PicmrePackage" is already installed,
Stage 1 is unnecessary.
NOTE: Do not connect the camera to
the computer at this time.
.4
/ Shut down all application
software in use.
• In Windows 2000, log on as Adminislralor
(aulhorized Adminislralors).
/ Insert the CD-ROM into the
computer, then click [USB Driver]
when the install menu screen
appears.
The "InstallShield Wizard" screen
appears.
• If the install menu screen does not appear,
double-click _ (My Computer) -4 {_
(P1CTUREPACKAGE).
3 Click [Next].
The USB driver installation starts.
When the installation is finished, the
screen informs you of completion.
4 Click the radio button next to
[Yes, I want to restart my
computer now] to select it, then
click [Finish].
O
Your computer restarts. Now, you call
establish a USB connection.
Remove the CD-ROM when the installation
is completed.
58
To Next Page
Loading...
