Sony DXC-637 - Fitting the Lens; Removing the Viewfinder

(Wa)dZE9-OXa
(on)z¢e9-0xa
6-1
In the case of the DXC-637K/637PK model, the lens is
already fitted. In other cases, use the following
procedure to fit the lens.
1 Remove the retaining rubber which prevents the
lens mount from coming loose, then raise the lens
fixing lever, and remove the lens mount cap. Retaining rubber
o>
Lens mount cap
2 With the lens fixing lever tumed fully
counterclockwise, push in the lens, aligning the
projection on the Jens with the cutout on the
camera.
3 Supporting the lens, turn the lens fixing lever fully
clockwise. Replace the retaining rubber on the
lens mount.
(Continued)
Attaching Other System Components
4 Using the triangular mark as a guide, push the lens
connector into the LENS connector on the camera
head, until it clicks into place. Fasten the cable
with the clamps.
H
i
LENS
connector
}
4
Triangular
mark
If using a lens with a 6-pin connector
This camera head has a 12-pin LENS connector. If the
jens cable has a 6-pin connector, fit an adaptor cable:
LO-612 (manufactured by Canon) or ECF-124
(manufactured by Fujinon) or equivalent.
Remove any microphone from the viewfinder before
beginning.
Fitting optional filters
Loosen the lens hood fixing screw to remove the lens
hood, then attach the filter,
Remove lens hood
Filter (optional)
1 Pull the viewfinder connector out of the VF
connector on the camera head.
VF connector
PURRRTURRELEET?