Sony DXC-637 - Fitting Microphones

Ol-k
(Ma) dZ€9-OXG
(on)ze9-0xa
2 Loosen the viewfinder left-to-right position fixing
ring, then pulling up the retaining catch, slide the
viewfinder out.
Retaining catch
Viewfinder left-to-right
position fixing ring
To fit the viewfinder
Reverse the removal procedure.
Adjusting the viewfinder position
To adjust the viewfinder left-to-right position, loosen
the left-to-right fixing ring, and to adjust the front-to-
back position loosen the front-to-back position locking
catch.
Viewtinder tront-to-back Hy
Viewtinder lett-to-right
Position locking catch
i Position fixing ring
Left eye adaptor
By fitting a left eye adaptor, you can use the camera
with your left eye to the viewfinder.
You cannot stow the camera attached with a left eye
adaptor in the LC-421 Carrying Case.
For details consult your Sony service representative.
To use a long microphone such as the optional ECM-
670/672, remove the supplied microphone holder, and
fit an optional CAC-12 Microphone Holder to the
camera, then mount the microphone in this holder.
Removing the supplied microphone
holder
Remove the two microphone holder retaining screws
(M4 x 6) from the viewfinder, remove the microphone
holder, then replace the screws in their original
positions.
heer g if Mé x 6 screws a t
21
Attaching Other System Components
Fitting the optional CAC-12 Microphone
Holder
Remove the two retaining screws (M3 x 8) for the
optional microphone holder, then use these screws to
attach the CAC-12 Microphone Holder.
Fitting an optional microphone
Use the following procedure to attach an optional
ECM-670 Microphone.
1 Loosen the screw of the CAC-12 Microphone
Holder, then open the holder and replace the
microphone adaptor with the one supplied with the
ECM-670 Microphone.
2 Insert the microphone in the microphone holder,
close the holder, and tighten the screw.
Connect the microphone cable to the MIC IN
connector.
Fitting optional microphones (operable with a
48 V supply) other than the ECM-670
Use the same fitting procedure as for the ECM-670,
but note the following differences with respect to the
microphone adaptor.
ECM-672: no microphone adaptor required.
22
fC //
Slender microphones (19 mm (?/« inch) diameter):
use the microphone adaptor supplied with the
CAC-12.