Sony EVI-HD1 - STATUS Menu

64 STATUS Menu
SYNC TYPE
Select the sync signal to be output from the
HD OUT COMPONENT connector.
SYNC: Outputs a tri-level sync signal.
VD: Outputs a vertical sync signal.
This item appears only when you select the
video signal format for the HD signal output
using the SYSTEM SELECT switch on the
camera.
STATUS Menu
The STATUS menu is used to display the
settings selected with the menus.
The STATUS menu consists of PAGE1 to
PAGE4. This menu only displays the current
menu settings, and you cannot change them
with this menu.
PAGE1: Shows the settings selected with
the EXPOSURE menu.
PAGE2: Shows the settings selected with
the PICTURE menu and the WHITE
BALANCE menu.
PAGE3: Shows the settings selected with
the PAN TILT ZOOM menu.
PAGE4: Shows the settings selected with
the SYSTEM menu. Also shows the
currently selected video format, the
channel of the Remote Commander, and
the baud rate of the VISCA
communication.
SYNC TYPE of the SYSTEM menu appears
only when you select the video format for
the HD signal output using the SYSTEM
SELECT switch on the camera.
The current video format and the VISCA
baud rate communication for the camera are
displayed. Even if you change the settings
after turning on the power, those settings are
ignored and are not changed on the display.
RESET n : OK You have reset the
camera settings stored
in POSITION 1 to 6 to
the default settings.
One push WB : OP During the white
balance adjustment in
the ONE PUSH white
balance mode, the
message blinks on the
screen.
One push WB : OK When the white
balance adjustment has
been done correctly in
the ONE PUSH white
balance mode, the
message is lit on the
screen.
One push WB : NG When the white
balance adjustment has
failed in the ONE
PUSH white balance
mode, the message
blinks the screen.
Note
Message When
Note