Sony GigaJuke NAS-E35HD - Transferring Programmed Tracks

27
GB
NAS-E35HD.GB.3-292-247-11(1)
To cancel a transfer
Press .
When you cancel a transfer, it may take a while
for the transfer to stop.
If you cancel a transfer aer it has started, the
track will not be transferred.
To select the destination memory on
a USB device for transferring
For some USB devices, you may have to select the
destination memory (for example, the internal
memory or a memory card) to which the audio
data is to be transferred. In this case, select the
memory as follows.
For details on which USB devices are compatible,
see page 71.
1 Select the USB function and connect the
USB device to the (USB) port.
2 Enter the Option menu, select “USB Select”,
and then select the destination memory.
3 Do the procedure from step 2 of
“Transferring audio data to a USB device”
(page 26).
Transferring programmed
tracks
When the play mode is set to “PGM” (program)
with the HDD function active, you can transfer
a program to a USB device connected to the
(USB) port (page 39).
1
With the unit stopped, program
play set, and the HDD function
active, press TRANSFER.
2
Press

/

to select “All Step”, and
then press ENTER.
Transfer starts.
Tip
e transfer time depends on the item being
transferred.
Example:
A 60-minute track (MP3/128 kbps) recorded from a
radio broadcast or through the AUDIO IN jack takes
about 6 minutes to transfer.