Sony HCD-241 - Playing Back Tapes (on Cither Deck a or B)

Playing Back Tapes (on either Deck A or B)
his section describes about a basic playback operation on
ither deck A or B.
1 Press TAPE. |
oOo o BY & &
eae ode ai Fal
K
2 Press & to open the cassette compartment,
insert the tape with the side to be played
back facing you and close the cassette
compartment.
EJECT
KQVOD'
v0 Moc \
(oo Boo '
'3 Press DOLBY NR to select the DOLBY NR
setting.
DOLBY NR
fa’
= ON, FFF
\
4 Press [> to start playback.
When the tape ends, playback automatically stops.
To stop playback, rewinding or fast forwarding,
press B®.
To pause, press IE.
To resume playback, press I again or &.
To rewind the tape, press 44.
To fast-forward the tape, press PP.
Notes
¢ During playback or recording on a deck, do not operate
the other deck. (When both decks A and B are in playback
mode, only playback from deck A will be audible.)
© Before turning the power off, be sure tu stup playback or
recording by pressing B.
What is the Dolby NR* system?
Dolby NR (noise reduction) system reduces tape hiss noise in
low-level, high-frequency signals. The system bousts these
signals in recording and lowers them in playback.
When listening to a tape recorded with Dolby NR, set the
DOLBY NR switch to ON.
* Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
"DOLBY" and the double-D symbol 00 are trademarks of Dulby
Laboratories Licensing Corporation.