Sony HCD-241 - Playing the Discs - Continuous Play

Playing the Discs —- Continuous Play
This section describes about the continuous play. This CD section can be played
up to 5 discs, and you can choose to play a disc or all discs.
Before playing a disc, turn on the POWER and set the function selector to the CD
mode.
f ge ne |
ee
peop
2 Place a disc with the label side up.
To play more than one disc, press DISC SKIP to turn
the disc tray and place up to 5 discs.
After placing discs, press & to close the disc table.
Press CONTINUE to choose whether to play
one disc or all discs.
Each time CONTINUE is pressed, "1 DISC” or "ALL
DISCS" appears alternately.
CONTINUE
ALL
eee DIIS ae
\ tafr2]tajre las |
16|171 18/19 |29]
4 Press the DISC SELECT button or [> to start
playback.
———— DISC SELECT ——_——
bewae
«
Disc being played
°
Selection numbers
which exist on the
‘oe
ut
2?
3
4s
Pht
selected
disc.
wee
a
:
-
retreats
ll
When
playback
of
a
!
++++-|
selection
is
finished,
* | that selection number
goes out.
Selection number
being played
Elapsed time in the
selection being played
To stop play, press @.
To stop play and open the tray, press S.
To stop for a moment during play, press #8.
Press E> or Of to resume playback.
Caution on adjusting volume
Do not turn up the volume while listening to a portion
with very low level or no audio signals. Otherwise, the
speakers may be damaged when a peak level portion is
played.
Notes
¢ The CD section is automatically turned off in the TUNER
mode. However only the OPEN/CLOSE and DISC SKIP
buttons on the CD player can be operated in any mode.
This is useful when recording on tape from CDs.
¢ The disc number of an empty tray will be displayed until
the empty tray is set to play. Once it is recognized as
empty, it will disappear.
To play an 8 cm (3-inch) CD
Place it on the inner circle of the tray. If the disc is provided
with an adaptor, first remove it. Do not put a normal CD (12
cm/5-inch) on top of an 8 em CD.
When there are no disc at all on the tray
“no d iSC" appears on the display.