Sony HCD-241 - Receiving Broadcast

Receiving Broadcasts
This section describes about the various convenient ways of tuning.
Before reception, be sure to connect the supplied AM and FM antenna.
1 Press TUNER.
Sy te): “eS: ster Te
The CD section is automatically turned off in the
TUNER mode.
2 Press BAND to select FM or AM.
BAND
3 Press DUAL MODE TUNING - or +.
For alower (7? Fer a higher
oe Me
¢ Tuning in automatically
Keep pressing DUAL MODE TUNING - or + for
about 1 second.
When a station is received, the automatic tuning
stops.
To stop automatic tuning
Press DUAL MODE TUNING - or +.
* Tuning in manually
Press DUAL MODE TUNING - or + to select the
Staion.
4 Repeat step 3 until the desired station is
received.
Indicators in the display
¢ “TUNED” appears when a station is tuned in.
¢ “STEREO” appears when an FM sterev program of
sufficient signal strength is received.
When an FM stereo program is noisy
If the stereo program is noisy, press the STEREO/MONO
button to change the mode over the MONO. This eliminates
the stereo effect, but the noise will be reduced.
To return to the stereo mode, press the STEREO/MONO
button again.
To change the AM tuning interval
The AM tuning interval is preset at the factory to 10 kHz to
match the frequency allocation system of your country. To
change the interval to 9 kHz, proceed as follows.
1 Press the POWER switch to turn on the unit.
2 Press TUNER.
3 Set the BAND selector to AM.
4 Press ther POWER switch to turn the unit off.
5 While pressing the DUAL MODE TUNING + button, press
the POWER switch to turn the unit on.
To reset the interval to 10 kHz, follow the same procedure.
Note
When the interval is changed, all stored stations will be
erased from the memory. After changing the interval, be
sure to store the stations again.