Sony HCD-541 - Playing Back Tapes (on Either Deck a or B)

Playing Back Tapes (on either Deck A or B)
This section describes about a basic playback operation on either deck A or B.
— ae
| SB boboss CO)
PC eh TIO ™ |
lier a
"TAPE" appears on the display.
2 Press 2 to open the cassette compartment,
insert the tape and close the cassette
compartment.
EJECT
3 Set DOLBY NR to the same position that was
used when the cassette was recorded.
OFF 8 C
DOLBY NR
EE
4 Set DIRECTION.
= CO RELAY
To playback one
side only DIRECTION
= CO RELAY
To playback both
sides continuously* ORECTION
em <a
“After playing back five times, playback
automatically stops.
5 Press <J or [> to start playback.
To playback from the front side, press >.
To playback from the reverse side, press <<].
The tape direction indicator lights up to show the
side you are listening.
To stop playback, rewinding or fast forwarding,
press &
To pause, press 81.
To resume playback, press 11, <I or >.
To fastwind a tape rightward, press PP.
To fastwind a tape leftward, press 44.
Notes
* During playback or recording on a deck, do not operate
the other deck. (When both decks A and B are in playback
mode, only playback from deck A will be audible.)
¢ Before turning the power off, be sure to stop playback or
recording by pressing @.
What is the Dolby NR* system?
Dolby NR (noise reduction) system reduces tape hiss noise in
low-level, high-frequency signals. The system boosts these
signals in recording and lowers them in playback.
* Dolby noise reduction manufactured under license from Dolby
Laboratories Licensing Corporation.
“DOLBY” and the double-D symbol 00 are trademarks of Dolby
Laboratories Licensing Corporation.