Sony HCD-541 - Playing the Discs - Continuous Play

Playing the Discs — Continuous Play
This section describes about the continuous play. This CD section can be played up to 5
discs, and you can choose to play a disc or all discs.
Before playing a disc, turn on the SYSTEM POWER and set the function selector to the
CD mode.
7
POWER
4
Press
DISC
SELECT
or
[>
to
start
playback.
ee
ee Seo= —_—_—_——
i
bh
The & indicator lights up. Selection numbers
which exist on the
selected disc.
When playback of a
selection is finished,
that selection number
goes out.
fds Se ep
EET oo +} 00
ecg Ooo bee (I) |
—sesecoiroy-
=
Selection number Elapsed time in the
being played selection being played
To stop play, press @.
To stop play and open the tray, press &.
To stop for a moment during play, press 88.
Press > or §§ to resume playback.
Caution on adjusting volume
Do not turn up the volume while listening to a portion
with very low level or no audio signals. Otherwise, the
2 Place a disc with the label side up.
To play more than one disc, press DISC SKIP to turn
the disc tray and place up to 5 discs.
After placing discs, press & to close the disc table.
speakers may be damaged when a peak level portion is
played.
Notes
* The CD section is automatically turned off in the TUNER
mode. However only OPEN/CLOSE and DISC SKIP on
the CD section can be operated in any mode.
This is useful when recording on tape from CDs.
* The disc number of an empty tray wil] be displayed until
the empty tray is set to play. Once it is recognized as
empty, it will disappear.
To play an 8 cm (3-inch) CD
Place it on the inner circle of the tray. If the disc is provided
Press CONTINUE to choose whether to play with an adaptor, first remove it. Do not put a normal CD (12
one disc or all discs. cm/5-inch) on top of an 8 cm CD.
Each time CONTINUE is pressed, "1 DISC" or "ALL
DISCS" appears alternately. When there are no disc at all on the tray
CONTINUE "no d !SC" appears on the display.
1oIsc
aan IIIS
I- Jd 1S5C
21