5
HCD-DP700
This section is extracted from
instruction manual.
1 Turn on the system.
2 Press CLOCK/TIMER SET on the
remote.
When you set the time for the first time,
proceed to step 5.
3 Press cursor V/v repeatedly to select
CLOCK SET.
4 Press ENTER.
5 Press cursor V/v repeatedly to set the
hour.
6
Press ENTER.
7 Press cursor V/v repeatedly to set the
minute.
8 Press ENTER.
The clock starts working.
If you have made a mistake or want to change the
time, start over from step 2.
Note
The clock settings are canceled when you disconnect
the power cord or if a power failure occurs.
To Next Page
Loading...
