Press
+'+
repeatedly to select
the item. Then, press
G).
Tips
• When Auto Calibration starts:
- Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
- Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
- Press
1/6
or MUTING.
- Press input buttons on the remote
or
INPUT
SELECTOR
on the receiver.
- Change the volume level.
- Press AUTO
CAL
again.
1 Confirm the measurement
result.
2
Item
RETRY
SAVE
WARNCHK
PHASE
DISTANCE
LEVEL
Explanation
Performs the Auto
Calibration again.
Saves the measurement
results and exits the setting
process.
Displays warning
concerning the
measurement results. See
"When you select
"WARN
CHK'''' (page 29).
Displays the phase
of
each
speaker (in phase/out
of
phase). See "When you
select
"PHASE""
(page 29).
Displays the measurement
result for speaker distance.
Displays the measurement
result for speaker level.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement Display
result
Error code Cause and remedies
When error codes appear
Try the remedies and perform the Auto
Calibration again.
Exits the setting process
without saving the
measurement results.
EXIT
ERROR 32 None
of
the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and perform
the Auto Calibration again.
If
the optimizer microphone
is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly connected.
3 Save the measurement result.
Select "SAVE" in step
2.
The measurement results are saved.
Proceed to step
2.
Explanation
See "When
error codes
appear" (page
28).
SAVE
ERROR
XXXX
When the
measurement
process fails
When the
measurement
process
completes
properly
ERROR F 33 • None
of
the front speakers are
connected or only one front
speaker
is
connected.
• The optimizer microphone
is
not
connected.
28
GB
To Next Page
