Sony HVR-A1E - Page 94

94
HVR-A1E/A1P 2-639-668-11(1)
You cannot use [SHOT TRANS].
• You cannot use [SHOT TRANS] together with:
– NightShot
– [COLOR BAR]
Dubbing/Editing/Connecting to other devices
Pictures from connected devices are not displayed on the LCD screen or the
viewfinder.
• Set [DISP OUTPUT] to [LCD PANEL] (p. 65).
• You cannot input a signal to your camcorder if you press DISPLAY/BATT INFO while
[DISP OUTPUT] is set to [V-OUT/PANEL] (p. 65).
Pictures from connected devices cannot be zoomed.
• You cannot zoom the pictures from connected devices on your camcorder.
Time code and other information appear on the display of the connected
device.
• Set [DISP OUTPUT] to [LCD PANEL] while connected with an A/V connecting cable (p.
65).
You cannot dub correctly using the A/V connecting cable.
• You cannot input externally from a device connected with the A/V connecting cable.
• The A/V connecting cable is not connected properly.
Make sure that the A/V connecting cable is connected to the input jack of another device for
dubbing a picture from your camcorder.
When connected using an i.LINK cable (optional), no picture appears on the
monitor screen during dubbing.
• Set [VCR HDV/DV] on the (STANDARD SET) menu according to the requirements of
the connected device (p. 57).
You cannot add sound to the recorded tape.
• You cannot add sound to the recorded tape on this unit.
New sound added to a recorded tape on another camcorder is not heard.
• Adjust [ AUDIO MIX] from the [CH1, CH2] (original sound) side until the sound is heard
appropriately (p. 58).
Troubleshooting (Continued)