Introduction
8
Configuring LocationFree Player
Pre-release version
z Tips
• When you are using the monitor to communicate with the base station in
“Home mode” to watch TV, VCR or DVDs, you cannot use the NetAV
function from computers A or B to access the base station. However, if you
select [Allow AV interception by registered monitors.] check box when you
register the monitor, even if the monitor is being used to watch TV, VCR or
DVDs, you can still initiate a NetAV connection with the base station from
computers A or B.
• While the base station is feeding TV, VCR or DVDs to a remote computer with
the NetAV function, you cannot use the NetAV function with other monitors.
In other words, while computer A is accessing the base station with NetAV,
you cannot use NetAV on computer B to access the base station. The reverse
also applies.
Monitor
Computer A
NetAV
Base station
NetAV
Computer B
To Next Page
Loading...
