28
Playing MDs
z You can adjust the analog signal output level.
1 While the recorder is playing, press LEVEL/DISPLAY/
CHA (or DISPLAY) repeatedly until the line output
adjustment display appears.
2 Turn AMS (or press LEVEL +/_ repeatedly) to adjust
the output signal level.
z You can use Setup Menu to adjust the analog output level
1 Press MENU/NO twice.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Output Level,” then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to adjust the
output level, press AMS or YES.
4 Press MENU/NO.
z You can make EJECT not function during play or pause to
avoid ejecting the MD by mistake.
1 Press MENU/NO twice during stop.
“Setup Menu” appears in the display.
2 Turn AMS (or press ./> repeatedly) to select
“Play Pause,” then press AMS or YES.
3 Turn AMS (or press ./> repeatedly) to select “Z
Disable,” then press AMS or YES.
4 Press MENU/NO.
To function EJECT, select “Z Enable” in step 3.
To Next Page
Loading...
