12
GB
Setting up for Windows 98/98SE
Installing the USB driver
1 Connect the system stereo component to the computer directly or
via the PC connecting adaptor, and then start up the computer.
“Add New Hardware Wizard” appears.
Quit any applications that are active.
2 Click “Next.”
3 Select “Search for the best driver for your device.
(Recommended).” (For the computer system with the CMT-C7NT
connected to it, refer to the operating instructions for that system
stereo component.)
Load the Windows 98/98SE CD-ROM into the CD-ROM drive of
the computer if the wizard requests it, and then install the drivers.
Installation procedure will be repeated for each of the following
devices.
• USB audio device
• USB composite device
• Generic USB hub
To Next Page
Loading...
