Sony MHC-V4D - Page 70

MHC-V3/V4D
70
Pin No. Pin Name I/O Description
109 PVcc - Power supply terminal (+3.3V)
110 TEST-MON4/SD_D0_0 O Test port for software checking.
111
ANALOG-CSEL/
SD_D1_0
O Multiplexer selector C for Analog input
112
RGB-TRANS-LED-
SPK/SD_WP_0
O Transfer signal to RGB driver (driver for Speaker LED)
113 LCDBCK_LED O LCD Backlight
114 ST-RDS I Input for RDS Text Detect Signal (L: RDS Detect)
115 ST-CE O Tuner IC: Tuner enable input pin
116 Vss - Ground terminal
117 PCONT-DAMP O Digital Amp Module Power Control Pin. “H”: ON
118 SPK_LED O LED Speaker Control
119 Vcc - Power supply terminal (+3.3V)
120 /AMP-RESET O Digital Amp Reset Pin
121 Vss - Ground terminal
122 CD-MOTOR+ O CDM turning motor control signal output
123 PVcc - Power supply terminal (+3.3V)
124 CD-MOTOR- O Loading motor drive signal output to the optical pick-up block (reverse direction)
125 CP-CLK O Serial data transfer clock output to the CPIC
126 CP-DATA I/O Two-way serial data with the CPIC
127 ST-CLK O Serial data transfer clock signal output to the tuner unit
128 ST-DATA I/O Two-way serial data with the tuner unit
129 NFC-IRQ I NFC wireless data receive signal input from the NFC section
130 NC - Not used
131 /AMP-SD I Digital Amp over current protection pin. “L”: Protect on
132 /DC-DET I DC detection pin. “L”: Protect on
133 BT-TxD O TX signal output terminal for Bluetooth section
134 LCD_INHB O LCD Inhibit Control
135 SIRCS I Remote control signal input
136 NC - Not used
137 NC - Not used
138 Vss - Ground terminal
139 USB_X1 - Not used
140 USB_X2 - Not used
141 USBDPVcc - Power supply terminal (+3.3V)
142 USBDPVss - Ground terminal
143 DM1 - Not used
144 DP1 - Not used
145 VBUSIN1 - Not used
146 USBDVcc - Power supply terminal (+3.3V)
147 USBDVss - Ground terminal
148 USBDPVcc - Power supply terminal (+3.3V)
149 USBDPVss - Ground terminal
150 DM0 - Not used
151 DP0 - Not used
152 VBUSIN0 - Not used
153 USBDVcc - Power supply terminal (+3.3V)
154 USBDVss - Ground terminal
155 REFRIN I USB reference power supply input terminal
156 USBAPVss - Ground terminal
157 USBAPVcc - Power supply terminal (+3.3V)
158 USBAVcc - Power supply terminal (+3.3V)
159 USBAVss - Ground terminal
160 USBUVcc - Power supply terminal (+3.3V)
161 USBUVss - Ground terminal
162 Vss - Ground terminal
Ver. 1.1