93
Installing the software onto your computer
Before installing the software
• Make sure to close any virus-check software, as such software usually demands a large
amount of system resources.
• When you use the MD Walkman, make sure to install the software with the supplied CD-
ROM.
— If OpenMG Jukebox, SonicStage or Net MD Simple Burner is installed already, the
previous software will be overwritten by the new version. The new version retains the
functions of the older version, but with new functions added.
— If SonicStage Premium or SonicStage Simple Burner is installed already, the previous
software will co-exist with the new version.
— You will still be able to use music data registered by an older software version even
after SonicStage has been installed. As a precaution, we recommend that you back up
your music data. To back up the data, refer to [Backing Up My Library] on SonicStage
Help.
The method for managing music data differs in part from conventional methods. For
details, refer to [For Users of Earlier Versions of SonicStage] in SonicStage Help.
• If the MD Walkman is connected to the computer with the USB cable, make sure to
disconnect the USB cable first before installing the software.
1 Turn on your computer and start up Windows.
2 Insert the supplied CD-ROM into the CD drive of your computer.
The setup program starts up automatically and the installation window appears.
3 When the [Region Selection] screen appears, select the region where the
SonicStage software will be used, and then click [Next].
continued
To Next Page
Loading...
Need help?
General
