72
Settings menu items (continued)
Menu Item Settings (*: Default setting)
Recording
Settings
S/N 100dB With two A/D converters for one channel, the linear PCM recorder
always reserves audio signals that are 12 dB lower than audio
processed in the normal circuit in addition to the normal audio
signals. If an over-input occurs, recorded data from the point at
which the over-input starts is replaced and compensated.
Replacement is executed while maintaining the linearity of two A/D
converters of different levels, realizing a high S/N ratio. Noise can be
suppressed even with a low recording level.
ON: S/N 100dB function is enabled.
OFF*: S/N 100dB function is disabled.
Note
If the S/N 100dB function is enabled, the LIMITER function is
automatically disabled.
LCF(Low Cut) When the low cut filter is activated, audio under the following
frequencies is filtered and attenuated. This function reduces noise
caused by the flow of an air-conditioner, outdoor air, etc.
OFF*: The LCF(Low Cut) function is disabled.
75 Hz: Audio under the 75 Hz frequency is attenuated.
150 Hz: Audio under the 150 Hz frequency is attenuated.
Note
The 75 Hz filter may slightly affect the recorded sound quality. If you
find that the setting is not effective enough, try “150Hz.”
Pre-Recording You can buffer sound for approximately 5 seconds in the memory
when you press the
REC button and the recorder is in standby for
recording mode. When you press the
PAUSE button or the
button to start recording, recording actually starts 5 seconds prior to
the point where the button is pressed (Pre-Recording function).
ON: The Pre-Recording function is activated. When you start
recording, the recorder starts recording sound 5 seconds prior
to the point where the button is pressed.
OFF*: The Pre-Recording function is disabled. When you start
recording, recording starts at the point where the button is
pressed.
Digital SYNC REC You can start recording simultaneously with input playback signals
from an external device connected to the LINE IN (OPT) jack during
digital recording.
ON: Synchronized recording is enabled.
OFF*: Synchronized recording is disabled. To start recording, press
the
REC button and the PAUSE button or the button.
Plug In Power When a plug in power type microphone is connected to the MIC
jack of the linear PCM recorder, the linear PCM recorder can supply
power to the microphone. You can turn the Plug In Power function
on and off:
ON: The linear PCM recorder supplies power to the connected
plug in power type microphone.
OFF*: The linear PCM recorder does not supply power to the
connected plug in power type jack.
To Next Page
Loading...
