SATA Interface
The CPU board is connected to mSATA SSD (CN2600/HPR-46 board) with the SATA interface to control them and for
mutual data transfer.
I2C Interface
The CPU board is connected to following device with the I2C interface to control them and for mutual data transfer.
• KMBC (FPGA) (IC2100/HPR-46 board)
• PRAC (CPLD) (IC2300/HPR-46 board)
• power monitor PLD (IC2500/HPR-46 board)
• FAN control IC (IC2603/HPR-46 board)
• RTC IC (IC2604/HPR-46 board)
• EEPROM for Far Cry (IC2605/HPR-46 board)
• Temperature sensor IC (IC2606/HPR-46 board)
• FPAC (FPGA) (IC401/FP-182 board)
1-13-6. I/O Interface System
REMOTE (9P)
The REMOTE signal is connected to the driver/receiver IC704 from the REMOTE (9P) connector (CN700 on the SY-425
board), and then connected to the IO CPU (IC1) on the SY-425 board, and controlled.
Time Code
Input side
The input signal of the time code is input from the BNC connector (the left one of the CN5, twin connector on the SY-425
board) of the TIME CODE IN, and then connected to the PHOT (IC900) on the HPR-46 board via the buffer/amplifier
circuit (IC700, IC701).
Output side
The output signal of the time code is output from the PHOT (IC900) on the HPR-46 board, and then output from the
BNC connector (the right one of the CN5, twin connector on the SY-425 board) of the TIME CODE OUT via the buffer/
amplifier circuit (IC701, IC702) on the SY-425 board.
Ethernet
Ethernet data, which is connected from the Ethernet 8-pin RJ45 connector CN600 on the SY-425 board to the Ethernet
interface IC (IC600), is converted to the PCI-Express (PCIe) signal.
Then the PCIe signal is connected through the CN-3594 board to the CPU board (IT CPU) on the HPR-46 board to be
controlled.
PMW-1000
1-35
To Next Page
