Sony PMW-500 - Loading Scene Files

Saving and Loading Scene Files
162
Chapter 7 Saving and Loading User Setting Data
5 To execute the save, select [Execute],
and then press the MENU knob.
To cancel the save, select [Cancel], and
then press the MENU knob.
If you selected Scene Store SxS >Execute in
step 2, the ACCESS lamp lights (in blue on
the right-side panel and in orange in the card
slot section) when you execute the save.
When the data has been saved, a completion
message appears and the ACCESS lamp goes
out.
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page 71) to the external device connector.
Select Scene Store USB >Execute in step 2.
To load a scene file from an SxS memory card,
insert the SxS memory card into a memory card
slot, and then proceed as follows.
See “Basic Setup Menu Operations” (page 107) for
information about menu operations.
1 Select FILE >Scene in the setup menu.
2 Select Scene Recall Mem >Execute (if
you want to load the file from the
camcorder’s internal memory), and
select Scene Recall SxS >Execute (if you
want to load the file from an SxS
memory card).
3 Press the MENU knob.
A list box of scene files appears. File
numbers where “No File” is displayed are
empty file numbers.
4 Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5 To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you selected Scene Recall SxS >Execute in
step 2, the ACCESS lamp lights (in blue on
the right-side panel and in orange in the card
slot section) when you execute the load.
When the data has been loaded, a completion
message appears and the ACCESS lamp goes
out.
When using a USB flash drive (in UDF mode)
Connect a formatted USB flash drive (see
page 71) to the external device connector.
Select Scene Recall USB >Execute in step 2.
Loading Scene Files