Sony RCD-W10 User Manual

5
Note on High-Speed
Synchro-Recording
Certain CD conditions may cause sound
dropout or noise in the recording results, or
even create unwanted tracks on the CD-R or
CD-RW. If this happens, clean the CD as
instructed in “On cleaning” above, and
record material to the CD-R or CD-RW
using normal speed Synchro-Recording only.
Note on CD-R or CD-RW
playback
When you playback a CD-R or CD-RW
recorded by a CD-R or CD-RW recorder,
you may not be able to playback depending
on the recording conditions (e.g., dirty disc,
etc.). Also, you should note that you need to
finalize a CD-R or CD-RW before playing
back on another system other than the one
used to make the recording. (Finalizing is a
process to complete the recording.)
After finalizing a CD-R, you can play it in
any conventional CD player. However,
depending on the state of the recording, there
may be sound skips during playback.
After finalizing a CD-RW, you can play it in
a CD-RW compatible player only.

Sony RCD-W10 Specifications

Power

North American model power requirements	120 V AC, 60 Hz
Mexican model power requirements	120 V AC, 60 Hz
Other models power requirements	110-120/220-240V AC, 50/60 Hz
Power consumption	25 W

Inputs

ANALOG IN impedance	47 kilohms
ANALOG IN rated input	500 mVrms
ANALOG IN minimum input	250 mVrms

Outputs

ANALOG OUT impedance	47 kilohms
ANALOG OUT rated output	2 Vrms
ANALOG OUT load impedance	over 10 kilohms

Weight and Dimensions

dimensions	430 × 108 × 399 mm
RCD-W50C mass	6.8 kg
RCD-W10 mass	6.0 kg